Details to be noticed in the installation of wallboard

- Dec 05, 2018-

As a healthy and environmentally friendly decoration material, integrated wallboard has been favored by more and more consumers, and it has become the preferred decoration material to enter users'homes. It is said that the installation of integrated wallboard is convenient, but there are many points needing attention in the installation of integrated wallboard.


1. Wooden structure design operation must pay attention to: according to the design requirements to do wooden structure, in the process of operation must pay attention to the wooden structure to do enough points for the fixing of integrated wallboard; the most edge to ensure the straight of the wooden square; as far as possible to make both sides of the right angle the size is the same; the structure is relatively solid; after the completion of the wooden structure, the actual wiring, reserved electrical wiring.


2. Installation sequence of roof and wall: integrated wall board is installed on top wall. Generally, installation begins from the top in the process of installation. In the process of cutting plate, it is necessary to make the material section straight and without burrs. The higher the speed of cutting saw, the less burrs.


3. Dimension error and line installation: The size error of integrated wallboard should not exceed two millimeters, otherwise, the joints will be irregular, which will affect the overall installation effect. In the process of installation of wall and background wall, if there are installation lines such as Yinjiao line, foot line, waist line, door sleeve line, window sleeve line, etc., we should pay special attention to the specification of lines when installing.


4. Installation details: bending at right angle. In the process of bending, the bending line must calculate the thickness of the wall in the process of internal bending. First draw the bending line, then take the material, generally around 8MM, bending as straight as possible. 45 degree splicing of concave and convex plates: after 45 degree cutting of plates, burrs are flattened, and then splicing. Attention should be paid to the right angle neat splicing, concave and convex plate right angle splicing: splicing plate inside the grinding 45 degrees angle for insertion, splicing plate will be directly inserted into another plate groove. Attention should be paid to angle control during grinding. Inside corner splicing of concave and convex plate: The splicing plate is sanded at 45 degrees outside to insert into the slot of another plate directly. Attention should be paid to angle control when grinding. Its principle is the same as bending at right angle.